Double ended UV lamp

Tue, 23 Jun 2026 08:37:53 +0800

Run a press with hybrid ink sets—UV-curable adhesives laid down alongside water-based color layers—and curing problems show up fast. You’ll see surface tack, interlayer adhesion loss, and color shift when the lamp spectrum doesn’t line up with the photoinitiators and resin chemistry. The double-ended UV lamp was built to fix that mismatch at the source. What matters under the hood We build the lamp around stable spectral output and repeatable energy delivery. High-pressure mercury vapor gives you a strong, broad emission band, and we shape the profile with dichroic-coated reflectors and selectable quartz envelopes. The payoff is consistent peak irradiance across the critical 365–405 nm window, where a lot of hybrid systems kick off cross-linking. Output stays flat over time. We’ve got units that run 5,000+ hours with less than 5% drop in UV intensity at the arc center, measured with a spectral radiometer. Low spectral drift matters because your ink supplier tunes photoinitiator absorption to a narrow band—drift forces you to chase cure by slowing the line. Why it holds up on mixed-ink jobs Mixed-ink printing needs spectral tuning, not just brute power. With a double-ended geometry, you can align the lamp to the curing window and run both ends at matched irradiance, so you kill the hot-spot/cold-zone issue across the web. Shift the spectral weighting—push 365 nm for a deeper cure, or 385–405 nm for surface cure—and you harden the UV layer without overheating the water-based undercoat. That means fewer rejects, stable dot gain, and adhesion you can count on. Energy use drops because you cure at the minimum required energy density, not whatever the lamp happens to throw. The shop-floor details you can’t skip Double-ended lamps are picky about orientation and end-of-life ignition stability. Install them to match the reflector geometry, and make sure the ballast matches the lamp’s arc length and power profile—mismatched ballasts shorten life and shift the spectrum. Plan for a warm-up period before irradiance settles, and replace lamps by hours, not by failure. Also, double-check your ducting and cooling capacity. High irradiance makes heat, and if airflow is short, thermal drift follows—output decay accelerates.

Double on UV Light China

Double ended UV lamp